|
|
|
|
|
|
|
изписва ми на дисплея Е50-какво означава това?бях я сложил на отложен старт за през ноща.сутринта направо я изключих от щепсъла но като погледнах видях че дрехите не са изпрани.пак я пуснах но -нищо,само завъртя един път.при следващия опит ми изписа минутите но не тръгна.после взе да ми изписва Е50. |
|
Всичко записи: 2 : Дата на рег-ция: Апр. 2008 : Отправено: 12 Април, 2008 - 12:00:24 |
|
|
|
Vialex
Super Member От: Стара Загора
|
|
|
Всичко записи: 1116 : Дата на рег-ция: Авг. 2006 : Отправено: 12 Април, 2008 - 13:59:43 |
|
|
|
|
|
|
това го видях но то не е ли за перални с платка ЕWM 1000?за моята ми казаха че е ЕWM 2000
четките ги смених-нищо. сега какво? чакам съвети |
|
Всичко записи: 2 : Дата на рег-ция: Апр. 2008 : Отправено: 12 Април, 2008 - 17:35:30 |
|
|
|
|
|
|
E51 - TRIAC which powers the motor short-circuited(TRIAC short-circuit cut-out activated or motor speed more than maximum speed) Cycle blocked with door closed (after 5 attempts) Loss of insulation on motor winding/wiring; main PCB
E52 - No signal from tachometric generator on motor (no signal after maximum time) Cycle blocked with door closed (after 5 attempts,the last after 20 sec) Motor; tachometric generator; wiring; main PCB
E53 - "Sensing" circuit of motor TRIAC faulty(input signal to microprocessor always 0V or 5V) Cycle blocked with door closed Main PCB
E54 - Relays contacts sticking (voltage on "sensing" circuit when the relays should be open) Cycle blocked with door closed(after 5 attempts) Loss of insulation on motor windings/wiring; main PCB
E55 - Motor circuit open Cycle blocked with door closed(after 5 attempts) Motor; wiring; main PCB
E56 - Problems with motor tachimetric generator Cycle blocked with door closed(after 5 attempts,last after 20') Motor (tachimetric generator);wiring; main PCB |
|
Всичко записи: 11564 : Дата на рег-ция: Дек. 2005 : Отправено: 14 Април, 2008 - 21:32:55 |
|
|
|